SGI Rackable C1000 User's Guide download pdf (Page 57)

Installing Memory

007-5688-001 35

Figure 5-6 Removing a DIMM Module

Memory Configuration

When configured with two processors, the SGI Rackable C2108-TY10 can be configured with a

maximum of eighteen memory DIMMs.

Unlike previous processors, the Nehalem-EP processor has the memory controller embedded

within the processor socket. There are nine memory DIMMs that are controlled by each processor.

If the node board is configured with only one processor the total number of memory DIMMs

supported with be reduced from 18 to 9.

See Figure 5-7 for memory DIMM locations.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 121 122

Rackable™ C2108-TY10 System 1
User’s Guide 1
Record of Revision 3
007-5688-001 vii 7
007-5688-001 ix 9
Contents 10
007-5688-001 xi 11
007-5688-001 xiii 13
007-5688-001 xv 15
About This Guide 17
Related Publications 19
Conventions 20
Product Support 20
Reader Comments 21
1. Introduction 23
2 007-5688-001 24
1: Introduction 24
Server Board Features 25
Server Chassis Features 26
Serial ATA Subsystem 27
Front Control Panel 27
Motherboard 27
Cooling System 27
6 007-5688-001 28
2. Server Installation 29
Warnings and Precautions 30
Rack Mounting Considerations 31
Circuit Overloading 32
Reliable Ground 32
007-5688-001 11 33
Outer Rack Rails 34
Install the Server in a Rack 35
Check the Node Board Setup 36
007-5688-001 15 37
Check the CPUs (processors) 38
Check the System Memory 38
Install Expansion PCI Cards 38
Check the Drive Bay Setup 38
Check the Airflow 39
Supply Power to the System 39
3. System Interface 41
Control Panel LEDs 42
007-5688-001 21 43
SATA Drive Carrier LEDs 44
4. System Safety 45
General Safety Precautions 46
ESD Precautions 47
5. Advanced Severboard Setup 49
Unpacking 50
Connecting the Control Panel 50
I/O Ports 51
Serverboard Details 52
Installing Memory 54
007-5688-001 33 55
Figure 5-4 DIMM Installation 55
34 007-5688-001 56
5: Advanced Severboard Setup 56
Memory Configuration 57
Front of Chassis 58
Rear of Chassis 58
Memory DIMM Rules 59
38 007-5688-001 60
007-5688-001 39 61
40 007-5688-001 62
007-5688-001 41 63
42 007-5688-001 64
007-5688-001 43 65
44 007-5688-001 66
007-5688-001 45 67
PCI Card Slotting 68
Installing Selected PCI cards 69
6. Advanced Chassis Setup 71
50 007-5688-001 72
6: Advanced Chassis Setup 72
Static-Sensitive Device 73
Control Panel 73
System Fans 74
Replacing System Fans 75
Accessing the Drive Bays 75
SATA Drive Installation 76
007-5688-001 55 77
Removing the Power Supply 79
Installing a New Power Supply 79
Starting BIOS Setup Utility 81
Starting the Setup Utility 82
Main Setup 82
System Time/System Update 83
Serverboard 83
Advanced Setup Configurations 84
Boot Features 85
Power Configuration 86
Processor and Clock Options 87
66 007-5688-001 88
007-5688-001 67 89
Advanced Chipset Control 90
007-5688-001 69 91
North Bridge Configuration 92
SouthBridge Configuration 93
72 007-5688-001 94
IDE and SATA Configuration 95
74 007-5688-001 96
007-5688-001 75 97
PCI/PnP Configuration 98
Remote Access Configuration 99
78 007-5688-001 100
Hardware Health Monitor 101
80 007-5688-001 102
ACPI Configuration 103
Trusted Computing 104
View BMC System Event Log 105
IPMI Configuration 105
Set LAN Configuration 106
IP Address Configuration 106
MAC Address Configuration 107
Subnet Mask Configuration 107
SEL PEF Configuration 108
DMI Event Log 109
Security Settings 110
Boot Configuration 111
Boot Device Priority 112
Exit Options 113
Save Changes and Exit 114
Discard Changes and Exit 114
Discard Changes 115
Load Optimal Defaults 115
Load Fail-Safe Defaults 115
A. BIOS Error Codes 117
B. System Specifications 119
98 007-5688-001 120
B: System Specifications 120
System Cooling 121
System Input Requirements 121
Power Supply 121
Operating Environment 121
Regulatory Compliance 122

Comments to this Manuals

No comments

SGI Rackable C1000 User's Guide Page 57

Comments to this Manuals

Related products and manuals for Servers SGI Rackable C1000